IVAC 7100 & 7200 Infusion Pump

IVAC 7100 & 7200
Volumetric IV Pump

The IVAC Signature Edition Infusion System includes the Model 7100 and Model 7200 Volumetric Infusion Pumps and AccuSLIDE Flow Regulator administration sets. This document provides directions for use for both model pumps.

The single channel provides a full range of features in a small, easy to-use, linear peristaltic pump.
The dual channel offers the same features while providing two, independent infusion pumps in one instrument.

The pumps may be used to deliver a wide variety of fluids over a broad range of infusion rates from multiple fluid container types.

The system is designed to be used in many areas of patient care, including:

General Floor
Labor/Delivery/Post Partum
Burn Unit
Medical/Surgical
OR/Anesthesia.
ICU/CCU
Post Op/Recovery

Oncology . Pediatrics
Cardiac Cath Lab
Mobile Intensive Care
Neonatology
Emergency
Nutritional
Hemodialysis

The pumps' applications include:

General IV fluids and electrolytes
TPN and hyperalimentation products
Antibiotics
Lipids
Blood and blood product

Solutions for irrigation procedures
Epidural
Anesthesia and analgesics
Enteral solutions
Cardiovascular drugs

The Signature Edition Infusion system uses a wide variety of AccuSlide Flow Regulator Administration sets. The IVAC 72 series sets are designed for use within the pumps as well as for gravity-flow, stand-alone use. The unique, patented AccuSlide flow Regulator has an integral flow control device that minimizes accidental free-flow when the set is removed from the pump and provides accurate rate control during gravity administration.

SPECIFICATIONS

Flow Rate Range	0.1 to 999.9 ml/hr in 0.1 ml/hr increments (primary) 1.1 to 270.0 ml/hr in 0.1 ml/hr increments (secondary)
Volume To Be Infused Range	.1 to 9999.9 ml in 0.1 ml increments (primary) .1 to 999.9 ml in 0.1 ml increments (secondary)
Volume Infused Range	0.0 to 9999.9 ml in 0.1 ml increments
Alarms	Air in Line Battery Depleted Channel Malfunction Computer Link Failure Flow Sensor Unplugged Hold Time Exceeded Instrument Malfunction Key stuck Latch Open No Upstream Flow Detected Occlusion Downstream Occlusion Upstream Primary Flow Detected during


Secondary	Set Out
	Set Up Time Exceeded
Dimensions
7100	Width 7.7 in/19.3 cm
	Height 8.6 in/21.8 cm
	Depth* 5.0 in/12.7 cm
	Weight** 6.85 lbs./3.11 kg
	Power Cord 10 ft/3 m
7200	Width 10.5 in/26.7 cm
	Height 8.6 in/21.8 cm
	Depth* 5.0 in/12.7 cm
	Weight** 8.4 lbs./3.7 kg
	Power Cord 10 ft/3m
*without pole clamp
Case	Impact resistant plastic
Power Requirements	100- 120 V~,50/60 Hz, 0.5A,3-wire grounded system (40 watts Max)
Ground Current Leakage	Tested to UL Standard 544 and CSA C22.2 No. 125 for medical and dental equipment.
Battery	Rechargeable nickel cadmium. With a new, fully charged battery, the pump will operate for 4 hours nominal at 100 ml/hr for a two channel instrument operating on both channels simultaneously.
Environmental Conditions
Operating	Temperature Range 10ºC to 40ºC (50ºF to 104ºF)
	Relative Humidity 15 to 95% Non-condensing
	Atmospheric Pressure 632 to 1031 mbar
Storage	Temperature Range -40ºC to 60ºC (-40ºF to 122ºF)
	Relative Humidity 5 to 95%
	Atmospheric Pressure 632 to 1031 mbar

ADMINISTRATION SETS	Use only IVAC 72 series administration sets.